Home > Asterisk, Software > Outbound dialing problem with Digium TDM400 and Trixbox

Outbound dialing problem with Digium TDM400 and Trixbox

I began seeing problems with the upgrade to Trixbox 1.2.3 and now with a fresh install of 2.0. I have not tested it thoroughly enough to say for sure, but I believe it was introduced with a newer version of zaptel. Asterisk began sending digits before the CO was ready, resulting in incorrect digits received. Adding a pause before dialing clears it up. To do that, you need to add a w or ww to the outbound dial prefix for each affected trunk in FreePBX. Cleared it right up for me.

Advertisements
Categories: Asterisk, Software
  1. No comments yet.
  1. No trackbacks yet.

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: